Removing Window Tint Glue From Glass

Short video on how to remove window tint and more importantly the glue that s left on your window.

Removing window tint glue from glass.

Just click and pay. You can remove the left over glue in under 6 minutes. Both ammonia and vinegar will dissolve tinted film adhesive although it may take several hours to do so. This is especially true when it comes to removing stickers from the glass.

Using a clean towel rub the adhesive away using your hairdryer to soften it as. Find the edge of the glass and run the razor between it. Separate the film from the glass around the edges. I had to peel off 10 year old tint that was baked to the glass by the sun.

After a few seconds gently apply pulling pressure on the film. To make the process much simpler apply two things to your window before you begin. Place it one the adhesive residue to allow it to soften. Hold the hairdryer about two inches from the window and run it on high until the glue melts enough to pry the edge up.

Use a spray bottle filled with soapy ammonia and spray down the film thoroughly. The wider the blade the more efficiently it will strip the plastic from the window. Grasp the film where it has already come loose from the glass and spray some of your soapy water mixture behind it. The first is heat.

To speed up the process apply a film of plastic wrap over the sprayed window to hold in the moisture. Tinting film can be removed with a properly sharpened razor blade. Spray the inside of the window with the ammonia based cleaner until it is saturated. Cleaning glue from glass windows is difficult because it can be easy to leave adhesive residue behind.

Then let it dry fully before proceeding. Take your solvent of choice nail polish remover lighter fluid acetone or even engine penetrating oil and soak a paper towel in it. Spray glass cleaner onto the surface of the glass and clean it thoroughly with a paper towel. Soaps and cleaners don t cut through window tint glue they are simply poor window tint adhesive removers.

If the glue has dissolved some film will come off. Angle the dryer so it hits where the film and window meet slowly peeling as the glue softens. You need a solvent to cut through all that window tint glue. Allow it to sit and respray as it dries.

Remember that window tint. Step 2 wipe with solvent. After peeling the sticker off adhesive and glue marks are left behind which can be a struggle to clean especially if the residue is sticky or greasy.