Although the rot was limited to an area approximately 3 ft.
Replacing wall tile with drywall.
Remove outlet covers and cut the electricity to the area where you will be removing the tiles.
Once you have tools and materials on hand it s time to begin the process.
Start by removing any excess adhesive from the wall.
This can be done with a scraper.
Loosen cracked tile using cold chisel and hammer.
The damage had spread about 9 in.
In modern construction shower tile is generally installed with a moisture barrier under a base of waterproof cement board so water damage is somewhat less likely.
Wash the wall with tsp tri.
Brush away any dust and fallen tile residue debris.
Clear the counter so you will have easy access to the backsplash.
Up the wall so we had to remove three courses of 4 in sq.
In older homes ceramic shower tile was often installed directly over drywall.
Wide we removed a 5 ft wide section all the way across the back wall of the tub so we could install a continuous piece of substrate with no vertical seams.
These walls are susceptible to water damage if the tile s grout joints develop gaps.
If existing tiles are beyond repair remove the tile and install a piece of wallboard in its place.
Regrout and seal the tile around.
Drywall repair self adhesive wall patch.
Use trowel to scrape the wall clean of loose debris 5.
Smooth edges of tile by rubbing it with a rubbing stone 8.
Tile to reach sound drywall.
Repair any loose or cracked tiles.
Mix thinset mortar with latex additive 9.
Remove loose tiles 4.
How to repair drywall after removing tile.
Fortunately drywall is relatively easy to replace.
Previously painted textured drywall prep.
To do so make sure all of the tiles are intact and secure.
Once the drywall surface is ready new tiles can be attached with tile adhesive or mastic.
If necessary use tile nippers to remove spacer lugs from edge of tile 7.
Removing wall tiles is different and more difficult than removing floor tiles because wall tiles are typically set very close together with minimal grout lines.
Dry fit the new tile to the wall 6.
Remove the tile and prepare the wall according to the corresponding instructions above or tile over the existing tile.
Start by removing any molding switch plates outlet covers and other hardware attached to the area being tiled.
For additional strength use an adhesive remover.
Unless this is a powder room and you are removing the tiles on walls with no fixtures consider replacing the tiles with either greenboard a water resistant form of drywall or fiberboard a.
Carefully use the hammer and putty knife to chisel off the tiles without gouging the.