Removing Door Panel 02 Town And Countrry

Open the side door all the way and remove the door latch retaining bolts.

Removing door panel 02 town and countrry.

The right side power sliding door will not close completely. Remove screws attaching trim panel to door from below map pocket. I have a 2006 chrysler town country van with power sliding doors. The power window motor screws are torx t 30.

Disconnect all electrical connectors leading to the latch assembly. If equipped remove window crank. Remove the two screws on the front and rear side of the front door trim panel. To remove the oem door speaker you ll need a torx t 25 screwdriver.

2006 chrysler town country van. In this video we re going to show you how to remove the front door panel on this 2005 chrysler town and country the same as most minivans of this era with the ones that have power windows. Town and country door panel removal dodge caravan door panel removal beeping dashboard dashboard instrument panel loss of power beeping issue. Want to remove driver side door panel to gain access to power window motor first remove the tweeter speker if equipped this comes off easily by gently prying from behind then remove the small panel behind pull handle you ll find a screw behind it remove that the next part is a little tricky the door grip needs to come off to achieve this place a small flat screwdriver at the top of.

Here is the procedure to remove the drivers front door panel removal. Remove the weather shield if necessary. Partially close the door and pull the latch assembly out of the side door inner panel. Note do not use the front door trim panel to remove the trim clips from the door inner panel.

Any ideas what needs to be. The tools needed to remove the door panel include a small flathead screwdriver a torx t 20 star bit screwdriver a flathead screwdriver or a plastic trim panel removal tool and needle nose pliers. Remove the appropriate side door trim panel. Remove switch bezel and disconnect power window memory switch.

The only tools you ll need are a 12 mm wrench to unhook the battery and then you ll need a phillips screwdriver and either a door panel clip tool or a putty knife. Using the trim pad removing tool pry the trim panel retaining clips from the door inner panel.