Remote Control Ceiling Fan Light Wont Turn Off

However the light on the fan works and the remote does control the light.

Remote control ceiling fan light wont turn off.

Turn off the ceiling fan and allow the blades to come to a full stop. Clean and lubricate the ball bearings. Typically there is also a wall switch. Generally you ll need to open the housing to find it.

Make sure the blue wire from the receiver is wired to the blue or black with white stripe if a hunter from the fan. I hope this helps. The process will change the frequency settings and allow the remote to work again. If you want to stop the fan but still use the light you have to use the pull cord or the remote.

You can use that to turn the fan on and off. To determine the cause of the fan speed malfunction follow the steps below. Wait for 30 seconds before turning the fan on again. But if you have a unit that has both a light and a fan the wall switch will usually turn off both of them.

My ceiling fan will not turn off. Reset the fan remote. The first step is to see if the remote was faulty. You will also find a corresponding set of dipswitches on the fan.

When i turn the power back on the fan goes back on. One of the wires from the ceiling should be capped off usually the red one. If you want to reset the remote. If the lights are still stuck on at this point it is time to replace the receiver.

Turn off the ceiling fan using the remote. It is controlled by a remote control only no switch. The bad news is the fan canopy must be dropped to access the receiver. Resetting your remote setting is easy and it only takes a few easy steps.

Run the ceiling fan for a few minutes. Once complete return the battery and cover the remote. Reset the remote of your fan. I tried replacing the battery for the remote already and i tried turning off the power to the house.

For 10 seconds hold down the off button. Hunter fan remote reset follows the same steps making the troubleshooting easy. The fan is on and won t turn off. This will sync the ceiling fan remote with the receiver.

If the above does not resolve the issue continue to the following steps to check for over heating. Turn of your fan using its dedicated remote control. Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. Change the switch setting to match the settings of the hand held remote control.

Dipswitches are toggle switches on the back of the remote. The remote module has a set of small dip switches on the side of the module. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow. Replace the ceiling fan capacitor.