Reinforcing An Old Shed Roof Trusses

Usually trusses are put 24 inches apart.

Reinforcing an old shed roof trusses.

With your help rotate the shed trusses 180 degrees so that they are in the upright position pointed part facing skyward. Stabilizing a sagging roof with trusses joists. When all the trusses are installed and the first row of decking is on this brace is removed. To hold them up until the decking of the roof is placed on top a 12 foot 1 inch by 4 inch piece of lumber is used.

Step 3 saw more wood studs to the exact size of boards and panels that you removed from the shed. Take 2 6x4 as long as your longest stored lumber and cut 2 inch deep grooves in them as wide as your 2x6 is thick every foot or so. When i bought my house the garage roof had a sag. Install these over your existing horizontal 2x6s 2 feet from the roof edge inside and paralel to the roof ends crosswise from your existing 2x6.

It can be nailed temporarily to each truss as the next truss is put in place. Each side of the iron should be four inches wide with the entire piece being at least two feet long. Connect the trusses to walls. Use a level to ensure each truss is in the correct position.

The first step to reinforcing the roof is to add an x to the frame. If you don t have an a frame roof you can run parallel boards between the studs to further offer support and to strengthen the frame. Simply take 2 diagonal pieces and place them between the trusses. You need to use the level to make sure that each truss is perpendicular with the ground or 90 degrees.

Reinforce frame boards that remain as part of the shed by cutting two studs per board one a foot long and the other 8 to 10 inches and nailing one on either side of the frame pieces.